Honda CR-V: WindshieldWashers

Pull the wiper control lever toward you, and hold it. The washers spray until you release the lever. The wipers run at low speed, then complete one more sweep after you release the lever.

READ NEXT:

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The

 Turn Signal and Headlights

1. Turn Signal 2. OFF 3. Parking and interior lights 4. AUTO 5. Headlights on 6. High Beams 7. Flash high beams *: If equipped Turn Signal - Push down on the lever to signal a left turn

 Daytime Running Lights

With the headlight switch in the off or position, the high beam headlights and the high beam indicator come on with reduced brightness when you turn the ignition switch to the ON (II)

SEE MORE:

 Intermediate Shaft

Intermediate Shaft Removal 1. Drain the automatic transmission fluid. Reinstall the drain plug with a new washer. 2. Remove the right driveshaft. 3. Remove the flange bolt (A) and two dowel bolts (B). 4. Remove the intermediate shaft (A) from the differential. Hold the intermediate shaft horizon

 DTC 83-26: No Signal From the Front Passenger's Weight Sensor (rear outer side)

NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Read the DTC. Is DTC 83-26 indicated? YES-Go to step 3. NO-Intermittent failure, the system is OK at this time. Go to Troubleshooting Intermittent Failures. 3. From INSPECTION m

© 2016-2025 Copyright www.hcrv.net