Honda CR-V: Compass Zone Selection

In most areas, there is a variation between magnetic north and true north. Zone selection is required so the compass can compensate for this variation. To check and select the zone, do this:

1. Press and hold the select/reset knob for 10 seconds to change the display to the reset mode.

2. Select the zone indicator by

2. Select the zone indicator by turning the select/reset knob. The display begins to blink. Push the same knob to enter this setting.

3. Find the zone for your area on the zone map. Each zone number (1 through 15) corresponds to a compass zone.

4. Turn the select/reset knob to select the appropriate zone number, and press the select/ reset knob to enter the number.

When the system does not accept the selected compass zone, you see ‘‘- -’’ in the direction display. Select appropriate zone number again.

Security System

READ NEXT:

 Security System

If equipped The security system helps to protect your vehicle and valuables from theft. The horn sounds and a combination of headlights, parking lights, side marker lights and taillights flash

 Rearview Camera and Monitor

On EX-L model with navigation system Whenever you shift to reverse (R) with the ignition switch in the ON (II) position, the rearview is shown on the navigation system screen. For the best p

 Cruise Control

Cruise control allows you to maintain a set speed above 25 mph (40 km/h) without keeping your foot on the accelerator pedal. It should be used for cruising on straight, open highways. It is

SEE MORE:

 DTC P2135: TP Sensor A/B Voltage Incorrect Correlation

CAUTION Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated. NOTE: Before you troubleshoot, record all freeze data and any o

 Text Data Display Function

Each time you press the TITLE button, the display shows you the text, if the disc was recorded with text data. You can see the album, artist, and track name in the display. If a disc is recorded in MP3 or WMA, you can see the folder and file name, and the artist, album, and track tag.

© 2016-2025 Copyright www.hcrv.net