Honda CR-V: Instrument Panel Brightness

You can change the instrument panel

You can change the instrument panel brightness only when the light switch is on.

Turn the knob on the lower part of the instrument panel to adjust the brightness.

You will hear a beep when maximum or minimum brightness is reached.

To reduce glare at night, the

To reduce glare at night, the instrument panel illumination dims when you turn the light switch to Turning the select/ or Turning the select/. Turning the select/ reset knob fully to the right until you hear a beep will cancel the reduced brightness.

READ NEXT:

 HazardWarning Button

Push the button between the center vents to turn on the hazard warning lights (four-way flashers). This causes all four outside turn signals and both indicators in the instrument panel t

 Rear Window Defogger

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is

 Parking Brake

To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again. The parking brake indicator on the instrument panel should go out when the parking

SEE MORE:

 Engine Oil Life Display

To see the current engine oil life, turn the ignition switch to the ON (II) position, then press and release the select/reset knob repeatedly until the engine oil life indicator appears. The remaining engine oil life is shown on the display according to this table: If the remai

 Under-hood/dash Fuse/Relay Box

Under-hood Fuse/Relay Box Removal and Installation Removal 1. Make sure you have the anti-theft codes for the audio and navigation system. If equipped with XM radio, write down the XM radio presets. 2. Make sure the ignition switch is OFF. 3. Disconnect the negative battery cable, then disconnect

© 2016-2026 Copyright www.hcrv.net