Honda CR-V: TripMeter
This meter shows the number of miles (U.S.) or kilometers (Canada) driven since you last reset it.
There are two trip meters: Trip A and Trip B. Switch between these displays by pressing the select/reset knob repeatedly.
Each trip meter works independently, so you can keep track of two different distances.
When you turn the ignition switch to the ON (II) position, the last selection is displayed.
To reset a trip meter, display it, and then press and hold the select/reset knob until the number resets to ‘‘0.0’’.
READ NEXT:
Instant Fuel Economy
This display shows the instant fuel
economy you are getting.
It shows the number of mpg (U.S.)
or l/100 km (Canada).
Average Fuel Economy
When either of the trip meters (trip
A or B) is displayed, your vehicle’s
average fuel economy since you last
reset that tripmeter can be shown
on the information display (mpg on
U.S. mode
Range (Estimated Distance)
This display shows the estimated
distance you can travel on the fuel
remaining in the tank.
This distance is estimated from the
fuel economy you have achieved
over the last few miles (kilomet
SEE MORE:
DTC P1116: ECT Sensor 1 Performance
Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P0111 is stored at the same time as DTC P1116,
troubleshoot DTC P0111 first, then recheck for DTC
P1116.
1. Check for poor connections or loose terminal
A/C Compressor
Replacement
NOTE: Do not install an A/C compressor into a system
unless you are completely sure that the system is free
of contamination. Installing the A/C compressor into a
contaminated system can result in premature A/C
compressor failure.
1. If the A/C compressor is marginally operable, run
the engine at i
© 2016-2025 Copyright www.hcrv.net
