Honda CR-V: Fuel Fill Door
Fuel Fill Door Adjustment
1. Remove the nut (A), then remove the open spring (B).
2. Slightly loosen the hinge mounting bolts (A).
3. Adjust the fuel fill door (B) in or out until it's flush with the body, and up or down as necessary to equalize the gaps.
4. Tighten the hinge mounting bolts.
5. Check that the fuel fill door opens properly and locks securely, and check that the rear of the door is flush with the body.
6. Reinstall the open spring and nut.
7. Apply multipurpose grease to each location indicated by the arrows.
8. Apply touch-up paint to the hinge mounting bolts and around the hinges.
Fuel Cap Adapter Replacement
NOTE: Take care not to scratch the body.
1. Remove the fuel pipe protector.
2. Remove the cap (A) by turning it counterclockwise.
3. From under the body, push out the hooks (A). Then turn the fuel cap adapter (B), and remove it from the fuel pipe.
4. Install the adapter in the reverse order of removal.
READ NEXT:
Upper/Lower Front Grille Replacement
Upper Front Grille Replacement
NOTE: Take care not to scratch the bumper and grille.
1. Remove the front bumper.
2. Remove the clips from the back of the front grille
and release the hooks (A), then
Cowl Cover Replacement
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and
Equipment Program; call 888-424-6857
NOTE:
Put on gloves to protect your hands.
Take care not t
SEE MORE:
Alternator Removal and
Installation
Removal
1. Make sure you have the anti-theft code for the
audio system and the navigation system (if
equipped), then write down the XM radio presets.
2. Disconnect the negative cable from the battery first,
then disconnect the positive cable.
3. Remove the drive belt.
4. Remove the drive belt aut
Master Cylinder
Master Cylinder Replacement
NOTICE
Do not spill brake flu id on the vehicle; it may
damage the paint; if brake fluid gets on the paint,
wash it off immediately with water.
Be careful not to damage or deform the brake
lines during removal and installation.
To prevent the brake fluid from flo
