Honda CR-V: TripMeter

This meter shows the number of miles (U.S.) or kilometers (Canada) driven since you last reset it.

There are two trip meters: Trip A and Trip B. Switch between these displays by pressing the select/reset knob repeatedly.

Each trip meter works independently, so you can keep track of two different distances.

When you turn the ignition switch to the ON (II) position, the last selection is displayed.

To reset a trip meter, display it, and then press and hold the select/reset knob until the number resets to ‘‘0.0’’.

READ NEXT:

 Instant Fuel Economy

This display shows the instant fuel economy you are getting. It shows the number of mpg (U.S.) or l/100 km (Canada).

 Average Fuel Economy

When either of the trip meters (trip A or B) is displayed, your vehicle’s average fuel economy since you last reset that tripmeter can be shown on the information display (mpg on U.S. mode

 Range (Estimated Distance)

This display shows the estimated distance you can travel on the fuel remaining in the tank. This distance is estimated from the fuel economy you have achieved over the last few miles (kilomet

SEE MORE:

 Symptom Troubleshooting

Hard Steering 1. Check the power assist. Is the initial turning load more than 34 N (3.5 kgf, 7.7 Ibf) ? YES-Go to step 2. NO-Power assist is OK. 2. Connect the P/S joint adapter (pump), P/S joint adapter (hose), and P/S pressure gauge T/N 07406- 0010001 (see page 17-9), T/N 07406-001000A or T/N

 Starting System

Component Location Index STARTER CUT RELAY UNDER-DASH FUSE/RELAY BOX STARTER Starter Circuit Troubleshooting Performance Test Removal and Installation Overhaul TRANSMISSION RANGE SWITCH Test Replacement Symptom Troubleshooting Index Engine

© 2016-2025 Copyright www.hcrv.net