Honda CR-V: Side Engine Mount Replacement

1. Support the engine with a jack and wood block under the oil pan.

2. Remove the power steering (P/S) fluid reservoir from the holder.

3. Remove the upper torque rod.

Honda CR-V. Side Engine Mount Replacement

4. Remove the ground cable (A), then remove the side engine mount bracket (B).

Honda CR-V. Side Engine Mount Replacement

5. Remove the side engine mount stiffener (A), then remove the side engine mount (B).

Honda CR-V. Side Engine Mount Replacement

6. Install the side engine mount, then install the side engine mount stiffener.

7. Install the side engine mount bracket (A), then loosely tighten the new bolt and nut (B), and loosely tighten the bolt (C).

Honda CR-V. Side Engine Mount Replacement

8. Install the ground cable (D).

9. Remove the air cleaner housing assembly.

10. Loosen the transmission mounting bolt and nuts (A).

Honda CR-V. Side Engine Mount Replacement

11. Raise the lift to full height.

12. Loosen the lower torque rod mounting bolt (A).

Honda CR-V. Side Engine Mount Replacement

13. Lower the vehicle on the lift.

14. Tighten the side engine mount mounting bolts and nut.

Honda CR-V. Side Engine Mount Replacement

15. Tighten the transmission mounting bolt and nuts.

Honda CR-V. Side Engine Mount Replacement

16. Raise the lift to full height.

17. Tighten the lower torque rod mounting bolt.

Honda CR-V. Side Engine Mount Replacement

18. Lower the vehicle on the lift.

19. Install the air cleaner housing assembly.

20. Install the upper torque rod, then tighten the new upper torque rod mounting bolts in the numbered sequence shown.

Honda CR-V. Side Engine Mount Replacement

READ NEXT:

 Transmission Mount Replacement

1. Loosen the upper torque rod mounting bolt (A). 2. Remove the air cleaner housing assembly. 3. Remove the powertrain control module (PCM) cover, then remove the three bolts securing the PCM. 4. R

 Side Engine Mount Bracket Replacement

1. Support the engine with a jack and wood block under the oil pan. 2. Remove the upper torque rod. 3. Remove the ground cable (A), then remove the side engine mount bracket (B). 4. Install the sid

 Cylinder Head

Special Tools Air Pressure Regulator Valve Guide Reamer, 5.5 mm Socket, 19 mm Holder Handle Adjuster Locknut Wrench Stem Seal Driver VTEC Air Adapter VTEC Air Stopper Air Joint Adapter C

SEE MORE:

 Playing the XM Radio (EX-L model with navigation system)

Playing the XM Radio (EX-L model with navigation system) Your vehicle is capable of receiving XM Radio anywhere in the United States and Canada, except Hawaii, Alaska, and Puerto Rico. XM is a registered trademark of Sirius XM Radio , Inc. and XMCANADA is a registered business name

 Alternator and Regulator Circuit Troubleshooting

1. Make sure the battery connections are good and the battery is sufficiently charged. 2. Connect a VAT-40 (or equivalent tester), and turn the selector switch to position 1 (starting). 3. Start the engine. Hold the engine speed at 3,000 rpm with no load until the radiator fan comes on, then let i

© 2016-2025 Copyright www.hcrv.net