Honda CR-V: Replacing a High-mount Brake Light Bulb

Honda CR-V (2006–2011) Owner's Manual / Maintenance / Lights / Replacing a High-mount Brake Light Bulb

1. Open the tailgate.

1. Open the tailgate.

Unlatch the top of the cover by pulling back on it with your hands.

2. Place a cloth on the side edge of

2. Place a cloth on the side edge of the cover to prevent scratches.

Remove the cover by carefully prying on the edge with a small flat-tip screwdriver and pulling the cover off.

3. Remove the socket from the light assembly by turning it one-quarter turn counterclockwise.

4. Pull the bulb straight out of its

4. Pull the bulb straight out of its socket. Push the new bulb straight into the socket until it bottoms.

5. Press the brake pedal to make sure the new bulb is working.

6. Put the socket back into the light assembly, and turn it clockwise to lock it in place.

7. Put the cover back on the light assembly. Push it in until it locks in place.

READ NEXT:

 Cleaning the Seat Belts

Dirt build-up in the loops of the seat belt anchors can cause the belts to retract slowly. Wipe the insides of the loops with a clean cloth dampened in mild soap and warm water or isopropy

 Floor Mats

The floor mats that came with your vehicle hook over the floor mat anchors. This keeps the floor mats from sliding forward, possibly interfering with the pedals, or backwards, making the f

 Audio Antenna

Your vehicle is equipped with an antenna at the rear of the roof . Bef ore using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand. This prevents the antenna

SEE MORE:

 Engine Lubrication

Special Tools Oil Filter Wrench Component Location Index OIL PAN WASHER DRAIN BOLT OIL PUMP OIL PUMP CHAIN GUIDE OIL PUMP CHAIN TENSIONER OIL CONTROL ORIFICE OIL FILTER OIL FILTER FEED PIPE OIL FILTER BASE ENGINE OIL GALLERY CAP OIL PRESSURE SWITCH Sym

 Shift Cable

Shift Cable Replacement 1. Lift the vehicle up on a lift or apply the parking brake, block rear wheels, and raise the *front of the vehicle. Make sure it is securely supported. 2. Remove the following parts: Heater control panel Dashboard center panel Center lower covers 3. Shift the shift le

© 2016-2025 Copyright www.hcrv.net