Honda CR-V: Engine Coolant Check
Honda CR-V (2006–2011) Owner's Manual / Before Driving / Service Station Procedures / Engine Coolant Check
Look at the coolant level in the radiator reserve tank. Make sure it is between the MAX and MIN lines. If it is below the MIN line, see Adding Engine Coolant on page for information on adding the proper coolant.
READ NEXT:
Actual Mileage and EPA Fuel Economy Estimates Comparison.
Fuel economy is not a fixed number.
It varies based on driving conditions,
driving habits and vehicle condition.
Therefore, it is not possible for one
set of estimates to predict fuel
economy
Fuel Economy Factors
The following factors can lower your
vehicle’s fuel economy:
Aggressive driving (hard acceleration and braking)
Excessive idling, accelerating and braking in stop-and-go traffic
Cold engine ope
SEE MORE:
DTC Troubleshooting
DTC P0506: Idle Control System RPM Lower
Than Expected
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed
Adding Engine Oil
Unscrew and remove the engine oil
fill cap on top of the valve cover.
Pour in the oil slowly and carefully
you do not spill any. Clean up any
spills immediately. Spilled oil could
damage components in the engine
compartment.
Reinstall the engine oil fill cap, and
tighten it securely.
© 2016-2025 Copyright www.hcrv.net
