Honda CR-V: Avoiding Obstacles

Debris in the road can damage your suspension or other components.

Because your vehicle has a high center of gravity, driving over a large obstacle, or allowing a wheel to drop into a deep hole can cause your vehicle to tip or roll over.

READ NEXT:

 Driving on Slopes

If you can’t clearly see all conditions or obstacles on a slope, walk the slope before you drive on it. If you have any doubt whether or not you can safely drive on the slope, don’t do i

 Crossing a Stream

Avoid driving through deep water. If you encounter water in your route (a small stream or large puddle, for example), evaluate it carefully before going ahead. Make sure it is shallow, flowi

 If You Get Stuck

Avoid driving on soft sand, deep mud, or other surfaces where you could get stuck. If you do happen to get stuck because of inclement weather or other conditions, choose a safe and appropria

SEE MORE:

 Torque Converter Housing

Mainshaft Bearing and Oil Seal Replacement Special Tools Required Adjustable bearing puller, 25-40 mm 07736-A01000B or 07736-A01000A Attachment, 62 x 68 mm 07746-0010500 Attachment, 72 x 75 mm 07746-0010600 Driver 07749-0010000 1. Remove the mainshaft bearing and oil seal using the adjustabl

 Opening and Closing the Hood

1. Park the vehicle, and set the parking brake. Pull the hood release handle located under the lower left corner of the dashboard. The hood will pop up slightly. 2. Reach in between the hood and the front grille with your fingers. The hood latch handle is above the ‘‘H’’ log

© 2016-2025 Copyright www.hcrv.net