Honda CR-V: Seat Heaters
Component Location Index

- DRIVER'S SEAT
HEATER RELAY (HIGH)
- DRIVER'S SEAT
HEATER RELAY (LOW)
- DRIVER'S SEAT CUSHION HEATER
- DRIVER'S SEAT-BACK HEATER
- FRONT PASSENGER'S
SEAT-BACK HEATER
- FRONT PASSENGER'S
SEAT CUSHION HEATER
- FRONT PASSENGER'S SEAT
HEATER RELAY (HIGH)
- FRONT PASSENGER'S SEAT
HEATER RELAY (LOW)

- DRIVER'S SEAT HEATER SWITCH
- FRONT PASSENGER'S
SEAT HEATER SWITCH
Circuit Diagram


Seat Heater Test
1. Remove the driver's or front passenger's seat.
2. Disconnect the 3P (A) and 2P (B) connectors from
the seat heater.
Driver's Seat

Front Passenger's Seat

3. Check for continuity between the seat heater
connector B (2P) No.1 and No.2 terminals. There
should be continuity.
4. Reconnect the seat heater connector B (2P) to the
seat-back heater.
5. Check for continuity between the seat heater
connector A (3P) No.1 and No.2 terminals, No.2
and No.3 terminals, and No.1 and No.3 terminals.
There should be continuity.
6. If the continuity is not as specified, replace the
appropriate seat heater.
Switch Test/Replacement
1. Remove the shift lever panel.
2. Disconnect the 6P (or 7P) connector from the seat
heater switch (A), then remove the switch.
* : Front passenger's

3. Check for continuity between the terminals in each
switch position according to the table.

: Front
passenger's seat heater switch
4. If the continuity is not as specified, replace the
switch.
READ NEXT:
Component Location Index
UNDER-DASH FUSE/
RELAY BOX
UNDER-HOOD FUSE/RELAY BOX
REAR WINDOW DEFOGGER RELAY
HVAC CONTROL UNIT
REAR WINDOW DEFOGGER SWITCH/
MIRROR DEFOGGER SWITCH
REAR WINDOW DEF
Component Location Index
IMMOBILIZER INDICATOR
IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver)
UNDER-DASH
FUSE/RELAY BOX
IMOES UNIT
(Built into the MICU)
PCM
IGNITION KEY
TRANSPONDE
SEE MORE:
Functional Diagram
The electronic control system consists of the powertrain control module (PCM),
sensors, and solenoid valves.
Shifting and lock-up are electronically controlled for comfortable driving under
all conditions.
The PCM receives input signals from the sensors, switches, and other co
The spotlights have a two-position
switch. In the DOOR position, the
lights come on when you open any
door. In the OFF position, the lights
do not come on.
The spotlights (with the switch in
the DOOR position) also come on
when you unlock the door with the
key or the remote transm
© 2016-2025 Copyright www.hcrv.net
