Honda CR-V: Oil Check
Wait a few minutes after turning the engine off before you check the oil.
1. Remove the dipstick (orange handle).
2. Wipe off the dipstick with a clean cloth or paper towel.
3. Insert the dipstick all the way back into its hole.
4. Remove the dipstick again, and check the level. It should be between the upper and lower marks.
If it is near or below the lower mark, see Adding Engine Oil.
READ NEXT:
Engine Coolant Check
Look at the coolant level in the
radiator reserve tank. Make sure it is
between the MAX and MIN lines. If
it is below the MIN line, see Adding
Engine Coolant on page for
information on add
Actual Mileage and EPA Fuel Economy Estimates Comparison.
Fuel economy is not a fixed number.
It varies based on driving conditions,
driving habits and vehicle condition.
Therefore, it is not possible for one
set of estimates to predict fuel
economy
SEE MORE:
DTC 71-2x ("x" can be 0 thru 9 or A thru F):
Short in Driver's Seat Position Sensor
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on, and is DTC 71-2x
indicated?
YES-G
Crankshaft and Piston Removal
1. Remove the engine assembly.
2. Remove the transmission.
3. Remove the drive plate.
4. Remove the oil pan.
5. Remove the oil pump.
6. Remove the cylinder head.
7. Remove the baffle plates.
8. Remove the 8 mm bolts.
9. Remove the bearing cap bolts. To prevent warpage,
unscrew the bolts in s
© 2016-2025 Copyright www.hcrv.net
