Honda CR-V: MICU Input Test

NOTE:

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.

2. Check the No. 12 (10 A), No. 13 (10 A), No. 15 (7.5 A), No. 16 (10 A), No. 17 (10 A), No. 18 (20 A), No. 19 (15 A), No. 21 (30 A), and No. 37 (7.5 A) fuses in the under-dash fuse/relay box. If any fuse is blown, replace it and go to step 3.

3. Disconnect the under-dash fuse/relay box connectors E, F, G, M, S, and T.

NOTE: All connector views are wire side of female terminals.

Honda CR-V. Exterior Lights

Honda CR-V. Exterior Lights

4. Inspect the connector and socket terminals to be sure they are all making good contact.

5. With the connectors still disconnected, make these input tests at the appropriate connector.

Honda CR-V. Exterior Lights

6. Reconnect the connectors, and do these input tests at the connectors.

Honda CR-V. Exterior Lights

Honda CR-V. Exterior Lights

Combination Light Switch Test/Replacement

1. Remove the dashboard lower cover.

2. Remove the steering column covers.

3. Disconnect the 12P connector (A) from the combination light switch (B).

Honda CR-V. Exterior Lights

4. Remove the two screws, then slide out the combination light switch.

5. Inspect the connector terminals to be sure they are all making good contact.

Light switch

Honda CR-V. Exterior Lights

Turn signal switch

Honda CR-V. Exterior Lights

6. If the continuity is not as specified, replace the switch.

READ NEXT:

 Headlight Adjustment

CAUTION Headlights become very hot during use; do not touch them or any attaching hardware immediately after they have been turned off. Before adjusting the headlights: Park the vehicle on a level s

 Turn Signal/Hazard Flasher

Component Location Index TURN SIGNAL SWITCH (Built into the combination light switch) TURN SIGNAL INDICATORS HAZARD WARNING SWITCH MICU (Built into the under-dash fuse/relay box) Circuit Diagr

 Interior Lights

Component Location Index With moon roof INDIVIDUAL MAP LIGHTS INTERIOR LIGHT SWITCH (Built into the moonroof switch) AMBIENT LIGHT (Built into the moonroof switch) CEILING LIGHT CARGO AREA LI

SEE MORE:

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped areas when used. To replace a front wiper blade: 1. Raise each wiper arm off the windshield, l

 Ignition Switch

The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and START (III). LOCK (0) - You can insert or remove the key only in this position. To turn the key, the shift lever must be in Park, and you must push the key in slightly. If the front wheels are turned, the

© 2016-2025 Copyright www.hcrv.net