Honda CR-V: MICU Input Test

NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.

1. Turn the ignition switch OFF.

2. Disconnect the under-dash fuse/relay box connectors E, F, G, K, R, and T.

NOTE: All connector views are wire side of female terminals.

UNDER-DASH FUSE/RELAY BOX CONNECTOR E (42P)

Honda CR-V. MICU Input Test

UNDER-DASH FUSE/RELAY BOX CONNECTOR F (34P)

Honda CR-V. MICU Input Test

UNDER-DASH FUSE/RELAY BOX CONNECTOR G (21P)

Honda CR-V. MICU Input Test

UNDER-DASH FUSE/RELAY BOX CONNECTOR K (8P)

Honda CR-V. MICU Input Test

UNDER-DASH FUSE/RELAY BOX CONNECTOR R (20P)

Honda CR-V. MICU Input Test

UNDER-DASH FUSE/RELAY BOX CONNECTOR T (34P)

Honda CR-V. MICU Input Test

3. Inspect the connector and socket terminals to be sure they are all making good contact.

4. With the connector still disconnected, make these input tests at the appropriate connector.

Honda CR-V. MICU Input Test

5. Reconnect the connectors to the under-dash fuse/relay box, and make these input tests at the connectors.

Honda CR-V. MICU Input Test

READ NEXT:

 Keyless/Power Door Locks/Security System

Component Location Index NAVIGATION UNIT or AUDIO UNIT IMMOBILIZER-KEYLESS CONTROL UNIT (Built-in receiver) MICU (Built into the under-dash fuse/relay box) HEADLIGHTS HORN HOOD SWITCH SECUR

 System Description

Security Alarm System NOTE: This applies to EX and EX-L models. The security alarm system is armed automatically after the doors, hood, and tailgate are closed and locked. For the system to arm, the

 DTC Troubleshooting

DTC B1026: Front Passenger's Door Lock Switch Signal Error (LOCK/UNLOCK) NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. 1. Cl

SEE MORE:

 Security System

If equipped The security system helps to protect your vehicle and valuables from theft. The horn sounds and a combination of headlights, parking lights, side marker lights and taillights flash if someone attempts to break into your vehicle or remove the audio unit. This alarm continues

 Hood

Hood Adjustment 1. Remove these items: Front bulkhead cover Front fender trim Cowl cover 2. Slightly loosen each bolt (A). 3. Adjust the hood alignment in this sequence: Adjust the hood right and left, as well as forward and rearward, by using the elongated holes in the hood hinges (B).

© 2016-2025 Copyright www.hcrv.net