Honda CR-V: Differential Disassembly

Special Tools Required

1. Remove the drain plug (A) and the oil filler plug (B) with sealing washers (C).

Honda CR-V. Rear Differential

2. Raise the locknut tab (A) from the groove of the clutch guide, making sure the tab completely clears the groove to prevent damaging the clutch guide.

Honda CR-V. Rear Differential

3. Install the companion flange holder (A) and holder handle (B) on the companion flange.

Honda CR-V. Rear Differential

4. Loosen the locknut (A) counterclockwise so its tab (B) comes out from the groove (C) in the clutch guide.

Torque: 147 N.m (15.0 kgf.m, 108 Ibf*ft)

5. Tighten the locknut (A) until its tab (B) aligns with the groove (C).

6. Remove any dirt from inside the groove in the clutch guide, then loosen the locknut.

7. Remove the locknut (A), the disc spring washer (B), the back-up ring (C), the O-ring (D), and the companion flange (E).

Honda CR-V. Rear Differential

8. Remove the eight mounting bolts (A) in a crisscross pattern in several steps, then remove the torque control differential case (B) and the dowel pins (C).

Honda CR-V. Rear Differential

9. Remove the shim (A) and the clutch assembly (B).

Honda CR-V. Rear Differential

10. Remove the six steel balls (A), the base cam (B), the thrust needle bearings (C), and the pressure plate (D).

NOTE: Do not lose the steel balls.

Honda CR-V. Rear Differential

11. Remove the oil pump drives haft.

Honda CR-V. Rear Differential

12. Remove the oil pump body assembly (A), the oil pump pin (B), the dowel pins (C), the magnet (D), and the ATF strainer (E).

Honda CR-V. Rear Differential

READ NEXT:

 Differential Reassembly

Exploded View Special Tools Required Holder handle 07JAB-001020A Companion flange holder 07RAB-TB4010B 1. Apply differential fluid to the rubber pinion of the ATF strainer (A), then install the A

 Differential Mount Replacement

Exploded View Differential Installation 1. Install rear differential mount assembly A to the rear differential assembly (B). 2. Jack up the rear differential. 3. Install the new set rings (A) onto t

 Driveline/Axle

Special Tools Oil Seal Driver Attachment, 52 x 55 mm Half Shaft Base Threaded Adapter, 24 x 1.5 mm Threaded Adapter, 26 x 1.5 mm Attachment, 35 mm I.D. Driver Inner Handle, 30 mm Oil Seal

SEE MORE:

 Piston, Pin, and Connecting Rod Replacement

Disassembly 1. Remove the piston from the engine block. 2. Apply new engine oil to the piston pin snap rings (A), and turn them in the ring grooves until the end gaps are lined up with the cutouts in the piston pin bores (B). NOTE: Take care not to damage the ring grooves. 3. Remove both snap rin

 Rear Window Wiper and Washer

1. OFF When you turn the wiper switch to the ‘‘OFF’’ position, the wiper will return to its parked position. 2. Rotate the switch clockwise to turn the rear window wiper ON. The wiper operates every 7 seconds after completing two sweeps. 3. Hold past ON to activate the rea

© 2016-2025 Copyright www.hcrv.net