Honda CR-V: Beverage Holders

Be careful when you are using the beverage holders. A spilled liquid that is very hot can scald you or your passengers. Liquid can also spill from the door pocket beverage holders when you open or close the doors. Use only resealable containers in the door pockets.

Spilled liquids can damage the upholstery, carpeting, and electrical components in the interior.

On vehicles with rear seat armrest

On vehicles with rear seat armrest

The rear seat also has a beverage holder in the center armrest. To use it, pivot the armrest down.

READ NEXT:

 Center Table

On LX and EX models To use the center table, pull up the outside edge of the table until it latches. To store it, pull the lever and lower the table. Sitting on or getting under the ta

 Lower Glove Box

Open the lower glove box by pulling the bottom of the handle. Close it with a firm push. Lock or unlock the glove box with the master key. The glove box light comes on when the parking li

 Upper Glove Box

Open the upper glove box by pushing up the lever. Close it by pulling down on the edge under the lever.

SEE MORE:

 Reminder Systems

Component Location Index GAUGE CONTROL MODULE MICU Circuit Diagram Control Unit Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. MICU 1. Turn the ignition switch OFF. 2. Remove the left kick panel. 3. Disconnect the under-dash fuse/relay box connectors.

 DTC P1116: ECT Sensor 1 Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0111 is stored at the same time as DTC P1116, troubleshoot DTC P0111 first, then recheck for DTC P1116. 1. Check for poor connections or loose terminal

© 2016-2025 Copyright www.hcrv.net